Shunt Brazed European Standards 100A Switch Relay for Stabilizer

Basic Data Dimension(mm) 29×25×27.1
Fat ( g ) 80
Make contact with Arrangement 2A/2B
Contact Substance AgSnO2
Ambient Temperature -forty five~+85ºC
Vibration 10~50Hz,.075mm
Shock 1000m/s²,(100g)
Specs Information Nominal Voltage 9~36VDC
Electricity Intake <2W
Working Voltage 7.2V
Max. Motor Voltage 24V
Max. Switching Existing 100 A
Surge Current 6000A/10ms
Motor Resistance(R±20%) 30Ω
Contact Score(Res) 250VAC,100A
Get in touch with Voltage <60mV
Speak to Resistance <0.6mΩ
Dielectric Strength Motor to Make contact with >4000VAC   1min
Across Open Speak to >2000VAC   1min
CZPTal Lifestyle >10000
Mechanical Lifestyle >100000
Pulse Time 40ms~60ms
Choosing-up Time <65ms
Release Time <65ms
Off Make contact with Distance ≥0.8mm
Insulation Resistance >1000MΩ(500VDC)

            Cautions of Latching Relay:
  
             1.Tips of relay’s input
            (1)Polarity-Make sure you check the polarity within of our technical specification, if single coil then”+ -” or “- +”are fantastic,

            you can alter it by 1 pulse.If double coil then it is needed to confirm “-+-” or “+-+”just before leaving the our factory.

            (2)Driving-Remember to energize the relay at our advocate pulse width, rated voltage for dependable efficiency, if one.five

            times or 2 occasions of benefit or lower driving situation plz affirm with our engineer.
            (three)Relays’contact position might be altered for the duration of transportation or set up owing to impact of external pressure,
            for that reason please reset to the necessary standing.

 

            two.Ideas of relay’s output
            (1)When deciding on the relay with tough connection,please steer clear of the external power on load terminals in the course of or right after

            the set up.

            (two)When the relay will be related with screw or bolts to the relays’ terminals, plz make certain your connection is

            fixed and stop relay from damages or other safety issues because of to temp. Increase..

            (three)The sampling signal wires of products are limited, please do not pull or torque throughout set up.

Shunt Brazed European Standards 100A Switch Relay for Stabilizer